Name: Investigation Effect Of Machining Parameters In Turning AISI D2 Steel (en Inglés)
Price: 53.10 USD
Availability: InStock
Author: Patel, Romil ; Patel, Jay
ISBN: 9786200003447

portada Investigation Effect Of Machining Parameters In Turning AISI D2 Steel (en Inglés)

Investigation Effect Of Machining Parameters In Turning AISI D2 Steel (en Inglés)

Formato

Libro Físico

Autor

Romil Patel

Jay Patel

Editorial

LAP Lambert Academic Publishing

Idioma

Inglés

N° páginas

Encuadernación

Tapa Blanda

Dimensiones

22.9 x 15.2 x 0.5 cm

Peso

0.14 kg.

ISBN13

9786200003447

Categorías

Ingeniería: general

Investigation Effect Of Machining Parameters In Turning AISI D2 Steel (en Inglés)

Romil Patel (Autor) · Jay Patel (Autor) · LAP Lambert Academic Publishing · Tapa Blanda

Libro Nuevo Importado

Envío: 24 a 31 días háb.

$ 106.20$ 53.10

-50%

Costos de importación incluídos en el precio ✅

Libro Nuevo

Quedan 10 unidades

$ 53.10

Llega entre el 24 Jul y el 06 Ago a Quito, Pichincha. Seleccionar ubicación

Agregar a lista de deseos

Reseña del libro "Investigation Effect Of Machining Parameters In Turning AISI D2 Steel (en Inglés)"

The aim of the present work is to investigate the effect of process parameter on surface finish and material removal rate to obtain the optimal setting of these process parameters and the ANOVA is also used to analysis the influence of cutting parameters during machining. L27 experimental runs based on an orthogonal array of full factorial method were performed. Additionally the ANOVA is also applied to identify the most significant factor. This work presents an experimental investigation of influence of the three most important machining parameters of Speed, Feed and Depth of Cut on surface roughness during turning of AISI D2 steel. The result indicated that the process parameter cutting speed feed rate and combination of both parameters have significant effects on surface quality of turning of AISI D2 steel. From ANOVA analysis surface roughness is mostly affected by cutting speed and feed rate so that surface roughness can be improve by decreasing the feed rate as well as increasing the cutting speed up to 66 m/min and after increasing cutting speed surface roughness decrease.