portada Optimization of Wire Drawing Process Parameters (en Inglés)

Optimization of Wire Drawing Process Parameters (en Inglés)

Formato

Libro Físico

Autor

Abid Mohammed

Assefa Tsegaw

Editorial

LAP Lambert Academic Publishing

Idioma

Inglés

N° páginas

100

Encuadernación

Tapa Blanda

Dimensiones

22.9x15.2x0.6 cm

Peso

0.16 kg.

ISBN13

9786203305593

Categorías

Ingeniería: general

Optimization of Wire Drawing Process Parameters (en Inglés)

Abid Mohammed (Autor) · Assefa Tsegaw (Autor) · LAP Lambert Academic Publishing · Tapa Blanda

Libro Nuevo Importado

Envío: 21 a 28 días háb.

$ 144.55$ 72.27

-50%

Costos de importación incluídos en el precio ✅

Libro Nuevo

Quedan más de 100 unidades

$ 72.27

Llega entre el 18 Sep y el 01 Oct a Quito, Pichincha. Seleccionar ubicación

Agregar a lista de deseos

Reseña del libro "Optimization of Wire Drawing Process Parameters (en Inglés)"

The main focus of this research was on improvement of wire drawing process in Kombolchasteel products industry by optimizing the processing parameters which, in turn, increases the life of the die and the wire. In order to achieve these goals and remain competitive, there should be a need to apply advanced computational tools, such as FE simulation. Optimizing the die wear factor which the smaller-the-better QCH, and wire strength is the larger-the-better QCH type, is the main interest. Six control factors, involving lubrication type, lubrication temperature, drawing speed, reduction ratio, bearing length, and pre tension, were investigated utilizing L18(OA). The grey relational analysis was conducted for the normalized signal-to-noise (S/N)ratios. The ordinal value of the grey relational grade was then used to decide optimal factor levels. It was observed that lubrication type with powder, lubrication temperature with 390c, drawing speed With 25m/mi, reduction ratio of 17.4%, bearing length of 1.16 mm and drum pre tension with 2000KN is the optimal combination factors. Analysis of variance was performed for grey relational grade to select the factors which affect the process.